Flash card partition table not parsed correctly (r33137)

[monni]

I have a Kingston 2 GB microSD card with 1966080 (0x001E0000) hardware sectors which is detected as 960 MB instead of 1920 MB.

partition table says...

partition 0: start = 0x000000FF, size = 0x003BFF01

Experienced behaviour: Doesn't mount

Expected behaviour: Should mount and show correct partition size

[axeld]

That is strange at least, as the only reason I could imagine this to happen would be a fixed block size somewhere, but my iPod with a 4K block size works without a problem.

Can you provide a syslog?

[monni]

relevant part of syslog:

KERN: usb_disk: request_sense: media changed
KERN: Media changed from /dev/disk/usb/0/2/raw
KERN: KDiskDeviceManager::_ScanPartition(/dev/disk/usb/0/2/raw)
KERN:   trying: partitioning_systems/intel/extended/v1
KERN:   returned: -1
KERN:   trying: partitioning_systems/intel/map/v1
KERN: intel: pm_identify_partition(12, 5: 0, 1006632960, 512)
KERN: Partition::SetTo(): active: 0
KERN: Partition::CheckLocation() - end after session: 2013265920 (session: 1006632960)
KERN: intel: _ParsePrimary(): partition 0: bad location, ignoring
KERN: Partition::SetTo(): active: 0
KERN:   returned: 0.5
KERN:   trying: file_systems/bfs/v1
KERN:   returned: -1
KERN:   trying: file_systems/devfs/v1
KERN:   returned: -1
KERN:   trying: file_systems/rootfs/v1
KERN:   returned: -1
KERN:   trying: partitioning_systems/amiga_rdb/v1
KERN:   returned: -1
KERN:   trying: partitioning_systems/apple/v1
KERN:   returned: -1
KERN:   trying: partitioning_systems/efi_gpt/v1
KERN:   returned: -1
KERN:   trying: partitioning_systems/session/v1
KERN:   returned: -1
KERN:   trying: file_systems/attribute_overlay/v1
KERN:   returned: -1
KERN:   trying: file_systems/cdda/v1
KERN: usb_disk: unhandled ioctl 10102
KERN:   returned: -1
KERN:   trying: file_systems/ext2/v1
KERN:   returned: -1
KERN:   trying: file_systems/fat/v1
KERN:   returned: -1
KERN:   trying: file_systems/iso9660/v1
KERN: identify(12, 0x8115ba40)
KERN:   returned: -1
KERN:   trying: file_systems/nfs/v1
KERN:   returned: -1
KERN:   trying: file_systems/ntfs/v1
KERN:   returned: -1
KERN:   trying: file_systems/reiserfs/v1
KERN:   returned: -1
KERN:   trying: file_systems/write_overlay/v1
KERN:   returned: -1
KERN:   scanning with: partitioning_systems/intel/map/v1
KERN: intel: pm_scan_partition(12, 5: 0, 1006632960, 512)

[axeld]

Can you try to find out which block size Linux detects for the device? The syslog output looks good, and since it detects exactly half of the actual size, I suspect a block size problem indeed. This should then be in the usb_disk driver, though.

[monni]

Linux shows two devices for it: /dev/sdd1 and /dev/sdi1

mika@palermo:~$ scsi_readcap /dev/sdd1
sg_readcap   /dev/sdd1
Read Capacity results:
   Last logical block address=1966079 (0x1dffff), Number of blocks=1966080
   Logical block length=512 bytes
Hence:
   Device size: 1006632960 bytes, 960.0 MiB, 1.01 GB
mika@palermo:~$ scsi_readcap /dev/sdi1
sg_readcap   /dev/sdi1
Read Capacity results:
   Last logical block address=3932159 (0x3bffff), Number of blocks=3932160
   Logical block length=512 bytes
Hence:
   Device size: 2013265920 bytes, 1920.0 MiB, 2.01 GB

First one looks same as Haiku detects now, which seems weird... Both device paths are readable.

[waddlesplash]

Still an issue?

[monni]

This is what hrev58314 shows for that 2GB memory card:

fat[28]: sector count missing
usb xhci 2: transfer error on slot 4 endpoint 3: Stall
usb error xhci 2: cancel queued transfers: halted endpoint, reset!
usb_disk: acquire_sem failed while waiting for data transfer: Operation timed out
usb_disk: operation 0x28 failed at the SCSI level

If I go to DriveSetup, it shows up as unreadable 1.88 GiB drive with Intel Partition Map but no recognisable file system.