Opened 10 years ago
Closed 3 months ago
#12175 closed bug (invalid)
There seems to be no ehci-pci driver
Reported by: | yayfoxes | Owned by: | mmlr |
---|---|---|---|
Priority: | normal | Milestone: | Unscheduled |
Component: | Drivers/USB/EHCI | Version: | R1/Development |
Keywords: | Cc: | ||
Blocked By: | Blocking: | ||
Platform: | All |
Description
My system is a Dell Inspiron 3531 Mid 2014 and Haiku won't boot off a USB flash drive because there's no USB driver.
lspci -vvv snippet:
00:1d.0 USB controller: Intel Corporation Atom Processor Z36xxx/Z37xxx Series USB EHCI (rev 0e) (prog-if 20 [EHCI])
Subsystem: Dell Device 0667 Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- DisINTx- Status: Cap+ 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR- INTx- Latency: 0 Interrupt: pin A routed to IRQ 23 Region 0: Memory at 90705000 (32-bit, non-prefetchable) [size=1K] Capabilities: [50] Power Management version 3
Flags: PMEClk- DSI- D1- D2- AuxCurrent=375mA PME(D0+,D1-,D2-,D3hot+,D3cold+) Status: D0 NoSoftRst+ PME-Enable- DSel=0 DScale=0 PME+
Capabilities: [58] Debug port: BAR=1 offset=00a0 Capabilities: [98] PCI Advanced Features
AFCap: TP+ FLR+ AFCtrl: FLR- AFStatus: TP-
Kernel driver in use: ehci-pci
Change History (7)
comment:1 by , 10 years ago
comment:2 by , 10 years ago
It's an anyboot image flashed to the whole drive overwriting the partition table and I created the flash drive by doing "dd if=haiku-nightly-anyboot.image of=/dev/sdb bs=8192". I did not run makebootable on the flash drive. The boot logo shows up, and the boot proceeds half way and finally Haiku kernel panics saying "PANIC: Did not find any boot partitions". I should be getting a backtrace. Problem is, I have no camera.
comment:3 by , 10 years ago
comment:4 by , 9 years ago
Well, it kernel panics "PANIC: Did not find any boot partitions". And, I get a boot logo all the way to the hard disk icon (the middle one), and then it panics. I don't know what else to add to this bug report.
comment:5 by , 5 years ago
Please retest with a recent nightly, and attach a picture directly if you can.
We have drivers for uhci, ohci, and ehci. So, that is not the problem.
"won't boot" is not very helpful.