Realtek 8168 Ethernet not working

[mrentropy]

RealTek 8168 isn't working booting via EUFI on a Kodlix N42-D system (Apollo Lake chipset).

device Network controller (Ethernet controller) [2|0|0]
  vendor 10ec: Realtek Semiconductor Co., Ltd.
  device 8168: RTL8111/8168/8411 PCI Express Gigabit Ethernet Controller

As far as I can tell, the device should be supported (past bug reports for Haiku, and listed under the 're' driver for FreeBSD).

Nothing is listed under /dev/net, nothing appears in the Network prefs panel, and ifconfig only shows the loop device.

[mrentropy]

listdev for Ethernet

[mrentropy]

The entire listdev

[mrentropy]

The Syslog

[diver]

[rtl81xx] (re) reset never completed!

[michaelvoliveira]

Wlan RTL8192EE is not supported by the FreeBSD driver too.
Realtek PCIe Wlan
vendor 0x10ec
id 818b

[mrentropy]

Using Haiku hrev52675, the device is now showing up in the Network preferences and /dev/net. However, Network preferences says that there is no link (there is). Disabling and re-enabling doesn't recognize the link.

The KERN: [rtl81xx] (re) reset never completed! line is still in Syslog.

[waddlesplash]

KERN: [rtl81xx] (re) PHY read failed
KERN: [rtl81xx] (re) attaching PHYs failed

This is the actual problem.

[waddlesplash]

Looks like there is a FreeBSD ticket about this: ​​https://bugs.freebsd.org/bugzilla/show_bug.cgi?id=186401

It's mentioned there that taking the interface down and then bringing it back up again works around the problem. So, please try that (though interface down/up on Haiku behaves slightly differently than on FreeBSD, so you many not get the side effect.)

[waddlesplash]

Please retest after hrev53174.

[waddlesplash]

If you have not yet, please retest after hrev56182.

[wirlaburla]

Not working for me either on R1B4, Static or DHCP. Attached syslog is for DHCP.